Tongue and groove

Tongue and groove is a method of fitting similar objects together, edge to edge, used mainly with wood, in flooring, parquetry, panelling, and similar constructions. A strong joint, it allows two flat pieces to be joined strongly together to make a single flat surface. Before plywood became common, tongue-and-groove boards were also used for sheathing buildings and to construct concrete formwork.

Each piece has a slot (the groove or dado) cut all along one edge or along two adjacent edges, and a thin, deep ridge (the tongue) on the opposite edge or edges. The tongue projects a little less than the depth of the groove. Two or more pieces thus fit together closely. The joint is not normally glued, as shrinkage would then pull the tongue off. The effect of wood shrinkage is concealed when the joint is beaded or otherwise moulded. In another assembly method, the pieces are end-matched. This method eliminates the need for mitre joints, face nailing, and the use of joints on 16 inch or 24 inch centres of conventional framing. For joining thicker materials, several tongue-and-groove joints may be used one above the other. In fine woodworking such as cabinet making, both glued dovetail joints and tongue-and-groove joints are used.

For many uses, tongue-and-groove boards have been rendered obsolete by the introduction of plywood and later composite wood boards, but the method is still used in higher-quality boards. Plywood may also be tongued all round to fit flush into a framed structure, and plywood for sub-floors used in platform framing is often supplied with tongue-and-groove edges.

In old sailor slang vernacular, a tonguin (pronounced ) refers to a small boat or raft of tongue-and-groove construction or to repairs made to such a craft.