Continuous-flow manufacturing

Continuous-flow manufacturing, or repetitive-flow manufacturing, is an approach to discrete manufacturing that contrasts with batch production. It is associated with a just-in-time and kanban production approach, and calls for an ongoing examination and improvement efforts which ultimately requires integration of all elements of the production system. The goal is an optimally balanced production line with little waste, the lowest possible cost, on-time and defect-free production.

This strategy is typically applied in discrete manufacturing as an attempt to handle production volumes comprising discrete units of product in a flow which is more naturally found in process manufacturing. The basic fact is that in most cases, discrete units of a solid product cannot be handled in the same way as continuous quantities of liquid, gas or powder.

Discrete manufacturing is more likely to be performed in batches of product units that are routed from process to process in the factory. Each process may add value to the batch during a run-time or work-time. There is usually some time spent waiting for the process during a queue-time or wait-time. The larger the batch, the longer each unit has to wait for the rest of the batch to be completed, before it can go forward to the next process. This queue-time is waste, Muda, and represents time lost that is not value-added in the eyes of the customer. This waste is one of the most important elements targeted for reduction and elimination in lean manufacturing.

Reducing the batch size{{cite web

The paradigm aim is to achieve single-piece flow where a single discrete unit of product flows from process to process. In effect, the batch quantity is one. If there is no change in part or product model, then this objective needs to be balanced against the additional handling time, and the work-centres that perform the process will typically have to be arranged in close proximity to one another in a flow-line. This is often a characteristic of repetitive-flow manufacturing and most manual assembly work is performed this way in the modern factory.

If there is a change in part or product model, then the process engineer should also consider to balance the changeover time with run-time. If the changeover time is long, as it might be on a machine, batch size reduction is typically preceded with setup reduction techniques such as single-minute exchange of die.

One methodology for repetitive-flow manufacturing is demand flow technology which combines the principles of repetitive-flow and demand-driven manufacturing. The production planning and control is linked to a pull signal that is triggered from a customer order or consumption of finished goods stock. A pull signal can also link a process to the down-stream, and synchronize the flow to the demand of the customer.