Compressed air filters

Working principle

Unfiltered compressed air frequently contains dust, oil, rust, moisture and other harmful substances, and therefore requires filtration. In the first stage of filtration, the compressed air passes through a tube-shaped mesh filter, which creates a coalescence effect. Here bigger particles are adsorbed on the filter and the water will condense into larger droplets, which can then pass into the separation chamber. The compressed air is slowed down, which makes the particles condense on a honeycomb-like pad, allowing the water droplets to travel to the bottom of the drainage system and through an automatic or electric drain valve to the discharge. In the first filtration stage more than 95% of the water droplets, oil and large particles are removed. This practice is most common for removing water, but is also used for removing oil.

In the second filtration stage, the air is passed through a fiber filter. This process generates thousands of small vortices and other disturbances that cause the airflow to be less uniform. In doing this, the air comes into contact with more surface area of the filtration medium. Fine particulate is then captured because it will not fit through the small pores in the fiber filter. However, there will be a small pressure drop due to the added resistance to the airflow. File:Reading Technologies Compressed air filter.jpg|Reading Technologies Compressed air filter

Types of filters

Particulate filters

Particulate compressed air filters are used to remove dust and particles from the air.

Activated carbon filters

Activated carbon filters utilize a composite carbon material to remove gases and odors from the air. They are used in factories where food is produced or for breathing gas.

Coalescing filters

High oil compressed air coalescing filters remove water and oil aerosols by coalescing the aerosols into droplets. This happens partially because of tortuous path and pressure drop. Coalescers remove both water and oil aerosols from the air stream, and are rated at particulate contamination through direct interception. Filtration of oil, water aerosols, dust and dirt particles to 0.01 μm the best achievable in industry.

Cold coalescing filters

Cold coalescing filters are coalescing filters operated at around 35 F, allowing them to be more effective at removing moisture.

Compressed intake filters

Intake filters are the first line of defense in filtering. These filters can remove contaminants down to 0.3 μm and can remove chemical contaminants.

References

References

1. Holloway, Michael. (2013). "Dictionary of industrial terms". Wiley John Wiley distributor.
2. "How to Remove Oil from Compressed Air Lines".
3. Vokes Air. "Terminology".