BMW xDrive

Predecessor

The first BMWs available with all-wheel drive were the 1985-1992 E30 325iX and 1991-1996 E34 525iX models. These cars use centre and rear differentials with viscous couplings to vary the torque split between wheels. The centre differential has a default front:rear torque split of 37:63, due to the planetary gear. Up to 80% of the torque can be transferred to the tripping axle, using the increasing shear force of the silicone fluid in the viscous coupling (due to the slotted/grooved plates inside the unit) as wheel slip causes one axle to spin faster than the other. The same principle applies to the rear differential varying the torque split between the rear wheels. The front differential has no locking function. All-wheel drive was discontinued when the E30 3 Series and E34 5 Series were replaced by the E36 and E39 respectively.

All-wheel drive was reintroduced in 2001 for the X5 SUV and E46 3 series 325xi, 330xi and 330xd sedans/wagons. The system is similar to the earlier version, except without the viscous couplings. Instead, the electronic stability control (DSC) system applies the brake to wheels that are slipping, helping transfer power to the wheels with traction.

Design

Unlike its predecessor, the xDrive system uses an electronically actuated clutch-pack differential that engages to send torque to the front axle. In the case of the 2018 X3 through X6 models, the default torque split is 40:60 and the system is able to send 100% of the torque to either axle. However, full torque transfer to the front axle can only be achieved if the rear wheels have absolutely no traction, as the rear drive shaft is hard-coupled to the transmission output. The wet clutch is applied through a high speed electric servo motor turning a cam-shaped actuator disc. In most vehicles, the system uses open differentials at the front and rear, relying on the brakes (controlled by the electronic stability control system) to transfer torque away from the slipping wheel on each axle.

The Magna Actimax is the transfer case used in nearly all BMW xDrive systems.

A different system is used on BMWs which are based on a transverse engine front-wheel drive platform, such as the BMW X1 (F48), BMW 1 Series (F40) and BMW 2 Series Active Tourer. These models use a GKN Driveline system which sends 100% of the torque to the front wheels by default, only sending torque to the rear wheels when the front wheels are slipping.

Dynamic Performance Control

An upgraded version of xDrive with torque vectoring, called 'Dynamic Performance Control' (DPC), was introduced on the 2008 BMW X6 and has since become available on other vehicles including the BMW X5 M. As per most torque vectoring systems, the primary function is to increase agility in cornering. The DPC system is also used by the electronic stability control (DSC) to correct for understeer/oversteer, with one reviewer commenting that it provided smoother results and avoided the temporary power loss associated with the traditional method of using individual wheel brakes in such situations.

The DPC system can distribute torque between the front and rear axles, and between the two wheels on the rear axle. The system uses a clutch pack and planetary gearset within the differential to overdrive a wheel or axle as required.

Applications

The first xDrive models (as opposed to the earlier all-wheel drive system) were released in 2003. These consisted of the newly released BMW X3 (E83) - ATC400 Transfer Case, facelifted BMW X5 (E53) - ATC500 Transfer Case. In the following years, the availability of xDrive increased throughout the model range, and it is currently available on most models.

The first BMW M models to use xDrive were the 2009 E70 X5M and E71 X6M models. The first non-SUV BMW M model to not be rear-wheel drive was the 2017 F90 M5, which was only available with xDrive.

In Canada, 50 percent of BMWs sold in 2005 were fitted with xDrive. As of 2010, BMW Canada stopped offering rear-wheel drive versions of models that were available with xDrive, for example the only BMW 6 Series (F12) 650i version available without xDrive in 2012 was the convertible version.

References

References

1. "First Look: 2019 BMW 8 Series Preview". NY Daily News.
2. "1985 BMW 3 E30 Sedan phase-I/2 X (4WD) full range specs".
3. "BMW E30 3 Series 325ix Technical Specs, Dimensions".
4. "1991 BMW 5 E34 Sedan X (4WD) full range specs".
5. "BMW xDrive and 4x4 Systems Explained".
6. "Model selection - 3'E46 - Touring".
7. (19 January 2017). "BMW XDrive Vs Audi Quattro - How Do They Differ And Which Is Best?".
8. "BMW xDrive".
9. (2016-06-23). "Magna celebrates five million transfer cases for BMW Group".
10. (12 March 2017). "Which to Buy: BMW X1 or MINI Countryman?".
11. "F48 technical training docs".
12. "2008 BMW X6 xDrive35i and xDrive50i". [[Car and Driver]].
13. GmbH, Interone Worldwide. "BMW X5 M : Dynamic Performance Control".
14. (2 June 2008). "2009 BMW X6 xDrive50i vs 2009 Infiniti FX50".
15. "Dynamic Performance Control".
16. (20 April 2016). "BMW xDrive - From the First Analog System to Hybrid All-Wheel-Drive".
17. Damon Lavrinc. (2010-10-18). "Six Things We Learned at BMW M". Autoblog.
18. "Winter driving test: BMW xDrive".
19. (10 November 2011). "Car Review: 2012 BMW 650i xDrive".